Manual Adjustment; Electronic Adjustment - Electrolux FAVORIT 44410 VI Manual De Instrucciones

8
Setting the water softener
°dH
11 - 14
4 - 10
< 4
1) No use of salt required.
You must set the water softener manually and electronically.

Manual adjustment

The appliance is set at the factory at position 2.
1. Open the door.
2. Remove the lower basket.
3. Turn the water hardness dial to position 1
or 2 (refer to the chart).
4. Install the lower basket.
5. Close the door.

Electronic adjustment

The water softener is set at the factory at level 5.
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold function buttons B and C until the indicator lights for function buttons
A, B and C start to flash.
4. Release function buttons B and C.
5. Press function button A.
– The indicator light for function button A continues to flash.
– The indicator lights for function buttons B and C go off.
– The end-of-programme indicator light starts to flash.
– You can hear an audible signal.
The setting function of the water softener is activated.
The end-of-programme indicator light flashes and an audible signal operates to show
the level of the water softener. The pause is approximately 3 seconds.
Example: 5 flashes / 5 intermittent audible signals - pause - 5 flashes / 5 intermittent
audible signals - pause - etc. = level 5
6. Press the function button A one time to increase the water softener level by one step.
7. Press the on/off button to save the operation.
Water hardness
°TH mmol/l
19 - 25 1,9 - 2,5
7 - 18 0,7 - 1,8
< 7 < 0,7
Water hardness setting
Clarke manually
13 - 17 1
5 - 12 1
< 5 1)
1
electronically
3
2
1)
1