Setting Operating Parameters - Vortice VORT HRW 20 MONO Instrucciones Para El Instalador

Setting operating parameters

With a suitable combination of commands you can program some of the appliance's operating parameters, as described
below:
Cycle time
The table shows:
column A: speed switch position;
column B: selected cycle time;
column C: number of LED flashes to confirm setting accepted.
Example: cycle time 50s:
• to select a cycle time 50s, set the speed
switch onto 1 and actuate the operating
mode switch, from whatever position it is in,
3 consecutive times within a maximum time
of 2s: the cycle time will be set to 50 s. A
successful setting is followed by the LED
blinking 1 time and then turning off.
Factory setting: 80s.
Number of connected units
• only for model HRW 20 RC: to select a number of units
connected to 1, 2, 4 (default):
set the speed selector on position 4 and actuate the
operating mode switch, from whatever position it is in, 3
consecutive times within a maximum time of 3s. The LED will
flash 4 times and then turn off.
• only for model HRW 20 RC: to select a number of units
connected to 3: set the speed selector on position 5 and
actuate the operating mode switch, from whatever position it
is in, 3 consecutive times within a maximum time of 3s. The
LED will flash 5 times and then turn off.
Filters reset
On both models it is necessary to reset the saturated filter status (LED on) after cleaning/replacing the filter, by taking the
following action:
set the speed selector A onto "0" /
Actuate the operating mode selector B 3 consecutive times within a maximum time of 2s. T o confirm the reset, the LED will
flash 3 times and then turn off. (fig.3,4)
3 3
3x
B
1 1
3x
4 4
A
B
3x
A
1
2
3
3x
2 2
3x
A
ENGLISH
B C
50 1
80 2
100 3
5