De Dietrich DOP450 Serie Instrucciones De Uso página 43

99633803_ML_A.qxd 06/06/05
Your oven displays the three pyrolysis symbols
pyrolysis cycle (non-adjustable)
You can select two other pyrolysis cycle lengths (
1:45, 1:30) that are non-adjustable by
turning the selector button.
The oven cannot be used for 2:00, 2:15 or 2:30.
This time includes the cooling time until the door
can be unlocked.
d) Enter the programme by pressing the selector button.
The door locks during the pyrolysis cycle (after approximately two minutes).
You can check the time at which the pyrolysis cycle should end by pressing the
touch control. At the end of the pyrolysis cycle, the
the door is unlocked
e) Turn off the oven by pressing the selector button.
f) When the oven is cool, use a damp cloth to remove the white ashes.
The oven is clean and once again ready for the cooking application of your choice.
Notes: The cleaning temperature cannot be adjusted. During the pyrolysis cycle, the oven
lighting is off. If your oven is not clean after a pyrolysis cycle, you waited too long to launch
the cleaning cycle. Repeat the cycle.
2) How do you program for delayed pyrolysis?
Follow the instructions described in the
"Programming for immediate pyrolysis" section, then
a) Press the
the pyrolysis end time flashes to indicate that it
is now possible to set it.
b) Adjust the pyrolysis end time by turning
the selector button.
Example: Pyrolysis ends at 5:00.
When the pyrolysis cycle is finished, press the selector button.
10:07 Page 43
How do you clean the cavity of your oven ?
touch control,
corresponding to a two-hours
symbol id displayed until
GB
43