Worx SAW XL WX429 Manual Original página 15

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
WARNING:
Do not release the handle until the saw blade
come to complete stop and do not touch saw blade
while the saw blade is running.
INTENDED USE:
The tool is intended for ripping and cross-cutting
wood and other materials in straight cutting lines,
while resting firmly on the work piece.
ASSEMBLY AND OPERATION
Action
Mounting and Removing the Blade
Safety switch and On/Off trigger
Cross and Rip Cutting
Parallel Guide
Adjusting the Cutting Depth
Adjusting the Cutting Angle
Pocket /Plunge
Sawdust Removal
Adjusting the Base Plate
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes too hot, please run your
circular saw no load for 2-3 minutes to cool the
motor. Avoid prolonged usage at very low speeds.
Protect saw blades against impact and shock. Cutting
with extreme force can significantly reduces the
performance capability of the tool and reduces the
service life of the saw blade. Sawing performance
and cutting quality depend essentially on the
condition and the tooth count of the saw blade.
Therefore, use only sharp saw blades that are suited
for the material being cut.
Choice of blades: 24 teeth for general work, approx.
40 teeth for finer cuts, more than 40 teeth for very
fine cuts into delicate surfaces, diamond for tile,
cement board, etc.
Only use saw blades recommended.
Compact Circular Saw
MAINTAIN TOOLS WITH
CARE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and
changing accessories. Inspect tool cords periodically
and if damaged, have repaired by authorized service
facility. Your power tool requires no additional
lubrication or maintenance. There are no user
serviceable parts in your power tool. Never use water
or chemical cleaners to clean your power tool. Wipe
clean with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
Figure
qualified persons in order to avoid a hazard.
Periodically clear dust and chips from guard and
See Fig. A
base to ensure proper performance.
See Fig. B
See Fig. C1, C2
ENVIRONMENTAL
See Fig. D1, D2
PROTECTION
See Fig. E1, E2
See Fig. F
See Fig. G1, G2
local authorities or retailer for recycling advice.
See Fig. H
See Fig. I
Waste electrical products must not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
15
EN