Specifications - Ikegami ISD-A33S Instruction Manual

10. Specifications

(1) Image Sensor:
(2) Pixel Number:
(3) Scanning system:
(4) Sync system:
(5) Video output:
(6) Resolution:
(7) S/N ratio:
(8) Minimum object illumination: 0.1Lx/F1.4 (VBS output : 50%)
(9) Wide Dynamic Range:
(10) AGC:
(11) White Balance Control:
(12) Private Mask Setting:
(13) Digital Noise Reduction:
(14) Camera ID:
(15) Local Setup:
(16) Video Flip function:
(17) Lens:
(18) Power Requirement:
(19) Power Consumption and
Current:
(20) Operating Temperature and
Relative humidity:
1/3.2-inch DPS CMOS sensor
Approx. 1,230,000 pixels,1280(H)×960(V)
525 TV lines / 59.94Hz, 2 : 1 interlace
Internal synchronization (Crystal-lock)
VBS 1.0Vp-p/75 ohms
MON.OUT 1.0Vp-p/75 ohms
Horizontal; 700 TV lines
Over 50 dB(p-p/rms)
0.14Lx/F1.6 (VBS output : 50%)
Built-in
ON /OFF (Variable) Selectable
ATW(Indoor/Outdoor/AUTO1/AUTO2)/PUSH/
PUSHLOCK/MANUAL, Selectable
Built-in. Up to 16 areas
Built-in, On or OFF, Selectable
2 Line, up to 26 characters
(alphanumeric and symbols)
By using the switch inside the camera, it is
possible to select and set items according to the
OSD.
Camera ID,AGC ON/OFF,ATW/PUSH/
PUSHLOCK/MANUAL selection and
adjustment,Wide Dynamic Range level,Back
Light Compensation On or Off,DNR ON/
OFF,Chroma level,P.Mask setting
Built-in. up or down, right or left, up and down or
right and left
Built-in. Vari-focal Lens:
f2.8mm ~ 11.0mm
f9.1mm ~ 21.5mm
DC 12 V (+10.5V ~ + 15V)
AC 24 V±10% (50/60Hz)
Approx. 2.0 watts
-10 to +50°C, RH 30% to 90%
(No Condensation)
E-17