KOBE Brillia Serie Instrucciones De Instalación Y Manual De Operación página 9

Preparation before Installation
NOTE: TO AVOID DAMAGE TO YOUR HOOD,
PREVENT DEBRIS FROM ENTERING THE
VENT OPENING.
-
Decide the location of the venting pipe from the
hood to the outside. Refer to Figure 1.
-
A straight, short venting run will allow the hood to
perform more efficiently.
-
Try to avoid as many transitions, elbows, and long
run as possible. This may reduce the performance
of the hood.
-
Temporarily wire the hood to test for proper
operation before installing. If the hood does not
operate, check the circuit breaker or house fuse.
If the hood is still not working, disconnect power
supply and check the continuity of all wire
connections.
-
Peel protective film off the hood (if any).
-
Use duct tape to seal the joints between pipe
sections.
-
If necessary, prepare back wall frame with cross
framing lumber for secure installation.
references on Table 1 and measurements on page
12-13, decide the level of the lumber. Refer to
Figure 2.
Hood Installation
CAUTION:
USE HAND TOOLS ONLY. DO NOT
OVER TIGHTEN SCREWS. IT MAY CAUSE
DAMAGE TO THE HOOD.
CAUTION: If moving the cooking range is
necessary to install the hood, turn off the
power in an electric range at the main electrical
box. SHUT OFF THE GAS BEFORE MOVING
A GAS RANGE. And use a protective covering
to protect cooktop and/or countertop from
damage.
1. Using references on Table 1 and measurements on
page 12-13, mark the leveling point of the hood.
Position mounting screws (provided) on the wall,
leaving 1/8" away from the wall as shown in Figure
3.
2. Align Hood-Mounting Bracket to the three screws
on the wall and hook hood into place. Tighten
screws to secure hood to the wall.
CAUTION
: MAKE SURE THE HOOD IS
SECURE BEFORE RELEASING.
Figure 1
Figure 2
Using
Figure 3
7