Viking MA 339 Manual De Instrucciones página 43

Item Designation
B Upper part of grass catcher
box
C Lower part of grass catcher
box
D Pin
M Safety plug
N Charger
O Battery
•
Instruction manual
MA 339 C:
E Sleeve
F Bolt
G Washer
H Nut
MA 339:
I Flat head bolt
J Cable guide
K Rotary handle
L Cable clip
The standard equipment may vary
depending on the country where
sold and version type.
7. Preparing the machine for
operation
7.1 General
Risk of injury!
Observe the safety instructions in
the section "For your safety" (
Remove the safety plug,
particularly before
performing any work on the lawn
mower ( 9.1).
0478 131 9926 B - EN
● Place the machine on level and firm
Qty.
ground when performing all the
1
operations described.
Upon delivery, the batteries are
1
charged to approx. 30%. They must
be therefore be charged before
2
being used for the first time.
1
● Charge battery (
1
7.2 Installing mono handlebar
(MA 339 C)
● 1 Insert sleeve (E) in the bore
1
on handlebar (1).
1
● 2 Fit two washers (G) with the convex
2
side facing inwards onto the sleeve.
1
● 3 Hold sleeve (E) and washers (G)
and insert together with handlebar (1)
into console (2).
2
1
● 4 Insert nut (H) into the console as
shown.
2
1
● 5 Insert bolt (F) from outside inwards
through the bores in handlebar (1) and
in console (2). Tighten bolt (F).
Tightening torque:
18 - 22 Nm
Installing electric cable:
● Insert the electric cable in strain relief
moulding (3) as shown, press into the
holders on the console and on
handlebar (4, 5) and fasten to the
handlebar using cable clip (6).
4.).
7.3 Installing dual handlebar
(MA 339)
Installing upper handlebar:
● Insert flat head bolt (I) through cable
guide (J) and attach electric cable (1).
● Fit dual handlebar (2) onto both lower
8.4).
handlebar sections (3). Insert flat head
bolts (I) – on right with cable guide (J),
on left without – through bores from
inside outwards and tighten with rotary
handles (K).
3
Installing cable clip:
● Install cable clip (L) on the upper
handlebar. Insert electric cable (1) as
shown. Close tab (4) and allow it to
engage.
Distance between the cable clip and
switch:
25 - 27 cm
7.4 Assembling the grass
catcher box
● Fit the upper part of the grass
catcher box (B) onto the lower part of
the grass catcher box (C). Ensure
correct location in the guides.
● Push pin (D) through the bores
provided from inside.
● Allow the upper part of the grass
catcher box (B) to engage in the lower
part of the grass catcher box using
slight pressure.
● Attach the grass catcher box (
4
5
9.6).
41