Viking MA 339 Manual De Instrucciones página 53

MA 339.0, MA 339.1 C
Cutting width 37 cm
Speed of cutting
utilities 3100 rpm
Cutter bar drive Permanent
Tightening torque for
blade fastening
screw 10 - 15 Nm
Cutting height 30 - 70 mm
Cutting height (Great
Britain only) 20 - 70 mm
Grass catcher box 40 l
Wheel diameter
(front) 150 mm
Wheel diameter
(rear) 180 mm
Sound emissions:
In accordance with Directive 2000/14/EC:
Guaranteed sound
power level L 90 dB(A)
WAd
In accordance with Directive 2006/42/EC:
Sound pressure level
at workplace L 77 dB(A)
pA
Uncertainty K 1 dB(A)
pA
MA 339.0
Length 122 cm
Width 42 cm
Height 107 cm
Weight (without
battery) 12 kg
Hand-arm vibrations:
Specified vibration characteristic in
accordance with EN 12096:
Measured value a 0,63 m/sec
hw
Uncertainty K 0,32 m/sec
hw
Measurement in accordance with
EN 20643
0478 131 9926 B - EN
MA 339.1 C
Length
Width
Height
Weight (without
battery)
Hand-arm vibrations:
Specified vibration characteristic in
accordance with EN 12096:
Measured value a
Uncertainty K
hw
Measurement in accordance with
EN 20643
Transporting STIHL batteries:
STIHL batteries meet the requirements
specified in UN manual
ST/SG/AC.10/11/Rev. 5 Part III,
subsection 38.3.
The user may transport STIHL batteries by
road to the place of use of the machine
without further restrictions.
Country-specific legislation must be
observed in the case of air or sea
transport.
For further transport instructions, see
www.stihl.com/safety-data-sheets
REACH:
REACH is an EC Directive for the
registration, evaluation, authorisation and
restriction of chemicals. For information on
compliance with the REACH Directive
(EC) No. 1907/2006, see
www.stihl.com/reach
2
2
135 cm
43 cm
110 cm
14 kg
2
0,80 m/sec
hw
2
0,40 m/sec
20. Troubleshooting
If necessary, contact a specialist
dealer; VIKING recommends VIKING
specialist dealers.
Fault:
Motor does not start
Possible cause:
– Battery not fully charged (one green
LED flashes on battery)
– Battery incorrectly inserted
– Safety plug is not inserted
– ON button not pressed
– Motor is overloaded because the grass
is too tall or too wet
– Motor overload protection activated
– Battery too cold or too warm (one red
LED illuminates on battery)
– Lawn mower too warm (three red LEDs
illuminate on battery)
– Humidity in machine and/or battery
– Mower housing is blocked
– Fuse in safety plug defective
– Machine defective (three red LEDs
flash on battery)
Remedy:
– Charge battery ( 8.4)
– Insert battery into battery compartment
( 8.3)
– Insert safety plug ( 9.1)
– Press the ON button ( 12.2)
– Do not switch on motor in high grass,
adapt cutting height ( 9.5)
– Allow machine to cool down (
– Warm up battery or allow to cool down
( 8.4)
– Remove battery from battery
compartment and dry; clean/dry battery
compartment ( 8.3)
– Clean mower housing (
10.5)
13.2)
51