Application tool
11 mm-wide HCS
push cutting edge
ATZ 52 SC
Starlock
52 mm scraper, ri-
gid
Fitting/changing the application tool
Remove the application tool if one has already been fitted.
To remove the application tool, use the hex key (12) to
loosen the clamping bolt (11) and remove the tool.
Position the required application tool (e.g. plunge cut saw
blade (10)) on the tool holder (7) so that the depressed
centre is facing downwards (see figure on the graphics page,
text on the application tool should be legible from above).
Turn the application tool to a position which is convenient
for the job at hand and allow it to lock into place in the cams
Selecting a sanding sheet
Different sanding sheets are available, depending on the material you are working with and the required surface removal rate:
Sanding sheet Material
– All wood and wood-based
materials (e.g. hardwood,
softwood, chipboard, con-
struction boards)
– Metal materials
– Paint
– Varnish
– Filler
– Bodyfiller
Attaching/changing the sanding sheet on the sanding
plate
The sanding plate (15) is fitted with a hook-and-loop fasten-
ing, allowing sanding sheets with a hook-and-loop backing to
be secured quickly and easily.
Tap the hook-and-loop fastening of the sanding plate (15)
before fitting the sanding sheet (16) to facilitate maximum
adhesion.
Position the sanding sheet (16) so that it is flush with one
side of the sanding plate (15), then place the sanding sheet
on the sanding plate and press it on firmly.
Bosch Power Tools
Material
Carpets, mortar, con-
crete, tile adhesive
of the tool holder (7). Twelve positions offset by 30° are
possible for this.
Secure the application tool using the bolt (11). Tighten the
bolt using the hex key (12) until the rounded head of the bolt
is lying flat against the application tool.
u
Application
For pre-sanding, e.g. of rough and uneven beams and
boards
For surface sanding and levelling of slight irregularities
For finish-sanding and fine sanding of wood
For sanding down paint
For sanding undercoats (e.g. removing brushstrokes,
paint drips and paint runs)
For final sanding of primers prior to painting
To ensure optimum dust extraction, make sure that the
punched holes in the sanding sheet are aligned with the
drilled holes in the sanding plate.
To remove the sanding sheet (16), take hold of it by an edge
and pull it away from the sanding plate (15).
You can use all sanding sheets, polishing and cleaning
fleeces from the Delta 93 mm series in the Bosch range of
accessories.
Sanding accessories such as fleece/polishing felt are at-
tached to the sanding plate in the same way.
Application
Scraping on a hard substrate;
Example: Removing mortar, tile adhesive and concrete
and carpet adhesive residues;
available as flexible scraper ATZ 52 SFC (soft carpet ad-
hesive/paint residues)
Check that the application tool is seated securely. Ap-
plication tools that are attached incorrectly or are not se-
curely fixed in place may come loose during operation,
thereby putting you at risk.
English | 21
Grit
Coarse
40
60
Medium
80
100
120
Fine
180
240
320
400
Coarse
40
60
Medium
80
100
120
Fine
180
240
320
400
1 609 92A 5V6 | (20.08.2020)