KOBE RA2230SQB-1 Instrucciones De Instalación Y Manual De Operación página 9

Preparation before Installation
NOTE: TO AVOID DAMAGE TO YOUR HOOD,
PREVENT DEBRIS FROM ENTERING THE
VENT OPENING.
-
Decide the location of the venting pipe from the
hood to the outside. (Figure 1)
-
A straight, short venting run will allow the hood to
perform more efficiently.
-
Try to avoid as many transitions, elbows, and long
run as possible. This may reduce the performance
of the hood.
-
Temporarily wire the hood to test for proper
operation before installing.
-
Important: Peel any protective film off the hood.
-
Use duct tape to seal the joints between pipe
sections.
-
If necessary, prepare back wall frame with cross
framing lumber for secure installation. Refer to
Table 1 and measurements on Page 13 to decide
the level of the lumber. (Figure 2)
-
Loosen hood-mounting brackets at the back of the
hood, adjust brackets and tighten screws as shown
in Figure 3.
-
If necessary, remove the rubber stand on the back
of the hood and discard.
Hood Installation
CAUTION
: USE HAND TOOLS ONLY. DO NOT
OVER TIGHTEN SCREWS. IT MAY CAUSE
DAMAGE TO THE HOOD.
CAUTION
: If moving the cooking range is
necessary to install the hood, turn off the power
in an electric range at the main electrical box.
SHUT OFF THE GAS BEFORE MOVING A GAS
RANGE. And use a protective covering to
protect cooktop
damage.
1. Using references in Table 1 and measurements on
Page 13, mark the leveling locations point for hood-
mounting bracket on the wall.
2. Secure two mounting screws (provided) to the wall,
leaving an 1/8" space from the wall. (Figure 4)
3. Align the hood-mounting bracket to the mounting
screws on the wall and hang hood into place.
4. Secure and tighten the mounting screws.
CAUTION
: MAKE SURE THE HOOD IS
SECURE BEFORE RELEASING.
and/or countertop
Figure 1
Figure 2
Figure 3
from
Figure 4
7