Num'axes CANICOM 800 Expert Manual De Instrucciones página 27

Gb - 27
 C button: Continuous stimulation
Press the C button to send a warning to your dog using static stimulations transmitted by the two contact
points located on the receiver collar, this will last for as long as the button is pressed but limited to 8
seconds maximum.
A transmission symbol will appear on the LCD screen of the remote control; the indicator light on the
collar goes from flashing green to permanent green while the stimulations are being sent.
If you press the C button for more than 8 seconds, the collar will automatically go into safety mode for a
few seconds before restarting itself normally.
 B button: Booster
Press the B (Booster) button to stop your dog instantaneously.
You can choose the level of stimulation you think to be the best for an immediate effect. As a result, you do
not need to press the "+" button.
Those static stimulations are transmitted by the two contact points located on the collar for as long as the
button is pressed but no more than 8 seconds maximum.
If you press the B button for more than 8 seconds, the collar will automatically go into safety mode for a
few seconds before restarting itself normally.
The stimulation level selected thanks to the Booster button can be different for each collar.
Programming the Booster button for the dog A or 1 (red strap):
- press the "A" or "1" button for approximately 5 seconds until the stimulation level flashes on the LCD screen
- press the "+" or "-" button to modify the stimulation level
- press the "A" or "1" button to confirm the level selected
Renew the same procedure to program the Booster button for the dog B or the dogs 2, 3 and 4.
 "+" and "-": stimulation level control buttons
Use the +/- buttons for rapid adjustment of the level of stimulation of the receiver collar.
15 levels of stimulation are available for CANICOM 800 Expert.
18 levels of stimulation are available for CANICOM 1200 Expert.
Level 1: very weak stimulation – Level 15 or 18: strong stimulation
Always start with the lowest level of stimulation.
 Back-lightning of the LCD screen
You can light the LCD screen for approximately 6 seconds by pressing briefly the On/Off button of the
remote control (approx. ½ second).