Know Your Product - SPARKY BPR 220E Instrucciones De Uso

injury to the user, as well as damage to the
tool.
the nameplate rating is harmful to the motor.
potential overheating.
must ensure that it has the right ampere rating
for your power tool and it is in safe electrical
condition.
WARNING: Always switch off and un-
plug the power tool prior to any adjustment,
servicing or maintenance.
cure stance. The power tool is guided more
securely with both hands.
determine if utility lines are hidden in the work
area or call the local utility company for as-
sistance. Contact with electric lines can lead
can lead to explosion. Penetrating a water
line causes property damage or may cause
electric shock.
area of the power tool.
ble. Do not touch the damaged cable and pull
the mains plug when the cable is damaged
while operating. Damaged cables increase
the risk of electric shock.
sure no one is below when using the tool in
high locations.
whenever possible.
machine or upon jamming the drill bit. Switch
the power tool immediately upon jamming the
drill bit. Watch out for high reactive torque
which may result in kick-back. The drill bit will
block if the power tool is overloaded or if the
bit jams into the material.
during operation and immediately after that;
they may be extremely hot. You may get seri-
ous burns.
particularly dangerous. Dust from light alloys
can burn or explode.
EN
never be left around the work area.
it down.
purpose. Any use other than those mentioned
in this Manual will be considered a case of
misuse. The user and not the manufacturer
shall be liable for any damage or injury result-
ing from such cases of misuse.
the safety regulations, the assembly instruc-
tions and the operating instructions found in
this Manual. All persons who use and service
the machine have to be acquainted with this
Manual and must be informed about its poten-
tial hazards. Children and frail people must not
use this tool. Children should be supervised
at all times if they are in the area in which the
tool is being used. It is also imperative that
-
you observe the accident prevention regula-
tions in force in your area. The same applies
for general rules of occupational health and
safety.
changes made to the tool nor for any damage
resulting from such changes.
rainy weather, or in moist environment (after
liquids and gases. The working place should
be well lit.
-
WARNING: When operating with chis-
els the mode selector switch 11 must always
be in «hammer» position!

Know your product

Before using the power tool, familiarize your-
self with all the operating features and safety
requirements.
Use the tool and accessories only for the ap-
plications intended. All other applications are
expressly ruled out.
1. Auxiliary handle
2. Rotary hammer journal
3. Locking sleeve
4. SDS plus socket
5. Depth gauge
6. Release button
7. Reversing switch