KOBE Premium Serie Instrucciones De Instalación página 17

Hood Installation
CAUTION: If required to move the cooking
range to install the hood, turn off the power on
an electric range at the main electrical box.
SHUT OFF THE GAS BEFORE MOVING A GAS
RANGE.
1. Using references in Table 2 and measurements on
Page 25, mark the leveling locations point for hood-
mounting bracket on the wall.
2. Secure two mounting screws (provided) to the wall,
leaving an 1/8" space from the wall.
3. Align the hood-mounting bracket to the mounting
screws on the wall and hang hood into place.
4. Secure and tighten the mounting screws.
CAUTION: MAKE SURE HOOD IS SECURE
BEFORE RELEASING.
Wiring to Power Supply
SAFETY WARNING
RISK OF ELECTRICAL SHOCK. THIS RANGE HOOD
MUST BE PROPERLY GROUNDED. MAKE SURE
THIS IS DONE BY SPECIALIZED ELECTRICIAN IN
ACCORDANCE WITH ALL APPLICABLE NATIONAL
AND LOCAL ELECTRICAL CODES.
CONNECTING WIRES, SWITCH POWER OFF AT
SERVICE PANEL AND LOCK SERVICE PANEL TO
PREVENT POWER FROM BEING SWITCHED ON
ACCIDENTALLY.
5. Connect the electrical wires.
-
Connect three wires (black, white and green) to
house wires and cap with wire connectors.
Connect according to color: black to black, white
to white, and green to green as shown on Figure
19.
-
If necessary to hide the electrical wire
connections, push wires back into the wiring box.
Access the wire connections underneath the
hood. To prevent any damage, make sure wires
do not slip between motor or any moving parts.
Figure 19
Figure 20
Figure 21
BEFORE
15