Error Messages - Beninca CP.BULL8 OM Manual De Instrucciones

If a transmitter code is already stored in the receiver, the radio remote copy can be carried out (without accessing to the
control unit).
IMPORTANT: This procedure should be performed with gate leaves open, during the TCA dwell time. Proceed as follows:
1 Press the hidden key of the already memorised transmitter.
2 Within 5 seconds, press the key of the already memorised transmitter which corresponds to the channel to be matched
with the new transmitter code. The flashing light switches on.
3 Within 10 sec, press the hidden key of the new transmitter.
4 Within 5 sec, press the key of the new transmitter to be matched to the channel selected at point 2. The flashing light
switches off.
5 The receiver memorises the new transmitter and exits immediately the programming mode.
The control unit checks the correct operation of the safety devices. In the event of faults the following messages can be
displayed:
Error, stroke self-learning or remote control code memorisationi.
ERR
Error, Phototest PHOT O.
ERR1
Error, Phototest PHOT C.
ERR2
Error, Encoder.
ERR3
Error, Motor.
ERR4
F1 Protection fuse for motor and blinker
F2 Protection fuse of accessories and signals
F3 Protection of 230V/115V line
Let us suppose it is necessary to:
- set an automatic closing time (TCA) of 100s
- activate pre-blinking
Perform the operations described below step by step:
Step Press Display
1
2
3
4
5
6
7
8
9
10
11
12
13
18
REMOTE COPY OF TRANSMITTER CODES
EXAMPLE OF PROGRAMMING
First menu
PAR
First function of the first menu
TCA
Value currently set for the function selected
040
Set the desired value with the <+> and <-> keys
100
The value is programmed
PRG
When programming has been made, the display goes to the function just set
TCA
Press <+> and <-> simultaneously to go to the higher menu
PAR
Second menu
Log
First function of the second menu
TCA
Press <-> several times to select PRE logic
Pre
Value currently set for the function selected
OFF
Set the desired value with the <+> and <-> keys
ON
The value is programmed
PRG
When programming has been made, the display goes to the function just set
Pre
Press <+> and <-> simultaneously to go to the higher menu and quit programming or
PAR
wait 30s.

ERROR MESSAGES

FUSES
Notes