Stanley RL HW Manual De Instrucciones página 15

NOTE:
• A single press of
• Holding the key down will move the slope axis
continuously, slowly at first, followed by a faster rate
when held for an extended time.
• Reference Figure
L
each key.
Speed
• Press to toggle through the available speed
settings from fastest to slowest to stopped.
Spot Mode
• Press to stopped (0 RPM) setting.
• Press to rotate the direction of the spot.
NOTE:
• A single press of
by 0,10°.
• Holding down the key will rotate the direction
continuously, slowly at first, followed by a faster rate
when held for an extended time.
• The laser will blink 3 x prior to moving at the faster rate.
• Reference Figure
M
for each key.
Scan Mode
• Press to cycle through available scan angles (15°
/ 45° / 90°).
• Press to rotate the direction of the scan.
• Press to turn OFF Scan Mode and return to the
last used speed setting.
77-496 / 77-429 / 77-439 / 77-497 / 77-427 / 77-441
will change slope by 0,01%.
for resulting slope direction for
will rotate the direction
for resulting rotation direction
NOTE:
• A single press of
by 2,0°.
• Holding down the key will rotate the direction
continuously, slowly at first, followed by a faster rate
when held for an extended time.
• The laser will blink 3 x prior to moving at the faster rate.
M
• Reference Figure for resulting rotation direction
for each key.
Digital Slope Mode (with Auto-Levelling)
• When powered ON, press
• LCD will indicate "X" axis adjust. Press
adjust axis value.
• LCD will indicate when at maximum slope angle. The
value will not continue any further in that direction.
• Press again to set the "X" axis and / or proceed to
the "Y" axis value adjust.
• LCD will indicate "Y" axis adjust. Press
adjust axis value.
• LCD will indicate when at maximum slope angle. The
value will not continue any further in that direction.
• Press again to set the "Y" axis and / or proceed to
use of laser tool in Digital Slope Mode.
• Laser tool begins Auto-Levelling as done when initially
powered ON and then the "X" and "Y" axis will slope to
the set values.
• To turn Digital Slope Mode OFF, the laser tool power
needs to be cycled. Press
back ON.
NOTE:
• A single press of
0,01%.
• Holding the key down will move the value continuously,
slowly at first, followed by a faster rate when held for an
will rotate the direction
.
to
to
2x to power OFF and
will change the value by
15