Maintenance And Cleaning - El Corte Inglés MIAMI Manual Del Usuario

HOW TO ASSEMBLE THE FAN
Remove the locking nut and blade cap by turning it anticlockwise
from the motor spindle. (Fig.1)
Place the rear guard into position. If this is done correctly, the carry
handle will be at the top, (Fig.2)
Fix the rear guard into position by replacing the locking nut tightly by
hand. Do not force the locking nut.
Press the fan blade and locking the blade cap by turning it clockwise
Lift out all locking clips on the front guard. (Fig.3)
Place the front guard into position and secure it by fastening the
clips over the outer rim. The screw and nut at the bottom of the
guard must be tightened (Fig.4)
25
OPERATION OF THE PRODUCT
1. On / Off and Speed Control
The ON/OFF and Speed is controlled by the Button Switch.
0 - The Fan is switched Off
1 - The Fan operates at the Low speed
2 - The Fan operates at the middle speed
3 - The Fan operates at the high speed
2. Angle Adjustment
Switch off the fan. Slightly loosen the Adjusting Screw by turning it
anti-clockwise. Adjust the fan to the desired angle and then tighten the
Adjusting Screw by turning it clockwise.
3. Oscillation Adjustment
Push the oscillation control to turn on the oscillation function, pull the
oscillation control to turn it off.
Tilt Adjustable Knob

MAINTENANCE AND CLEANING

Switch off and disconnect from the mains before
•
assembling or disassembling and cleaning.
Keep the air vents at the rear of the main body free from
•
dust or fluff– use a vacuum cleaner to remove these when
necessary. Do not probe any opening to remove fluff.
Fan component parts should be cleaned using damp
•
cloth or sponge.
Do not allow any water or other liquid to enter the motor
•
housing.
26
Oscillation Control