Silverline 998003 Manual De Instrucciones página 9

Contact
For technical or repair service advice, please contact the helpline on (+44) 1935 382 222
Web: silverlinetools.com/en-GB/Support
Address:
Toolstream Ltd.
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, United Kingdom
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
• For long-term storage, remove batteries and store separately
Disposal
Li-ion batteries should not be disposed of with household waste. If you do not know of a li-ion
battery recycling centre in your area, contact your local authority or original dealer for advice on
disposal of li-ion batteries.
Always adhere to national regulations when disposing of power tools that are no longer functional
and are not viable for repair.
• Do not dispose of power tools, batteries or other waste electrical and electronic equipment
(WEEE), with household waste
• Contact your local waste disposal authority for information on the correct way to dispose of power
tools and batteries
Troubleshooting
Problem
Red LED (19) does not illuminate and Battery (12) not charging
Battery has low capacity
Drill cannot be switched 'ON' (ON/OFF Trigger Switch (15) does
not move)
Drill does not start when ON/OFF Trigger Switch is pressed
Screws do not reach deep enough into the workpiece
Screws are driven too deep into the workpiece surface
Possible cause
Battery not fully seated
Battery Charger (16) not powered
Battery not being fully charged
Battery has been charged over 300 times and capacity has
started to reduce
The Forward/Reverse Switch (8) may be in the middle
("locked") position
Battery completely discharged
Defective Battery
Drill defective
Not enough torque; Torque Selector (3) setting too low
Low battery voltage
Too much torque; Torque Selector (3) setting too high
18V Combi Hammer Drill
Solution
Clean Battery and Battery Charger contacts
Recheck mains connection
Charge the Battery until Red LED is extinguished
This is normal for batteries. Contact your Silverline dealer to
purchase a replacement battery
Slide the Forward/Reverse Switch either to the left or right
Recharge Battery or replace with a fully charged battery
Replace Battery
Contact your Silverline dealer or authorised service centre
Choose a higher torque setting
Recharge Battery or replace with a fully charged battery
Choose a lower torque setting
silverlinetools.com
9