Imetec INTELLIVAPOR K1 Instrucciones Para El Uso página 18

Problem
EN
The plate (8)
remains cold or
does not heat up.
The plate
temperature LED
(1) goes on and
off.
Only a little steam
or none at all is
dispensed.
The impurities that
come out from the
steam holes stain
the garments.
Water leaks from
the plate (8).
16
Possible cause
There is no power supply.
Normal procedure.
The steam selector (4) is
set to 0.
There is not enough water
in the reservoir (11).
Chemical additives,
scented liquids or
descaling agents are
being used
Starch is being used.
The plate temperature is
too low due to the super-
steam button (3) being
pressed too often .
Solution
Verify whether the plug (11) is
inserted correctly or try inserting it in
another socket.
Ensure the O/I switch (10) is in
position "I".
The switching on and off of the LED
indicates the heating stage of the iron.
Set the steam selector (4) to the
desired field (Fig. B).
Fill the reservoir (11).
These substances damage the
product: do not add additives to the
water in the reservoir.
Always spray the starch on the
reverse side of the fabric.
Allow slightly longer intervals between
the jets of steam.