Attaching The Fan Blades; Installing The Led Light Kit - Kichler 330163 Manual De Instrucciones

ATTACHING THE FAN BLADES

CAUTION: Remove the rubber shipping blocks attached to the face
of the motor. These blocks keep the motor from shifting during
shipping and MUST be removed during installation.
Step 1. Attach the blade to the blade bracket using the screws and
washers as shown in Figure 15. Start screw into bracket. Repeat for
the two remaining screws.
Step 2. Make sure the blade is straight and tighten each screw.
Step 3. Fasten blade assembly to motor using "Pre-Installed"
mounting screws in the blade bracket.

INSTALLING THE LED LIGHT KIT

NOTE: Before starting installation, disconnect the power by turning
off the circuit breaker or removing the fuse at the fuse box.
Step 1. Loosen the three mounting screws on the inside of the light
kit panel. (Fig. 16)
Step 2. While holding the LED light kit under the fan motor, make
the wire connections. (Fig. 16)
- Black to blue
- White to white
Step 3. Tuck the connections neatly into the light plate. Place the
key holes on the LED light kit over the 2 screws previously loosened
from the light plate, turn the LED light kit until it locks in place at
the narrow section of the key holes. Secure by tightening all three
screws. (Fig.16)
14
| KICHLER.COM
Blade arm
Blade arm
Screw
Light kit
Screw
Screw
Washer
Blade
Fan motor
assembly
Fig. 15
Fig. 16