Installation Of Safety Support - Kichler Lucian II Manual De Instrucciones

INSTALLATION OF SAFETY SUPPORT

(required for Canadian installation ONLY)
A safety support cable is provided to help prevent the ceiling fan from falling.
Step 1. Attach the wood screw and washers to the ceiling joist next to the
mounting bracket but do not tighten. (Fig. 11)
Step 2. Adjust the length of the safety cable to reach the screw and washers by
pulling the extra cable through the cable clamp until the overall length is correct,
put the end of the cable back through the cable clamp, forming a loop at the end
of the cable. Tighten the cable clamp securely. Now, put the loop in the end of
the safety cable over the wood screw and under the washer. Tighten the wood
screw securely.
NOTE: Although the safety support cable is required for Canadian installations
only. It's a good idea to make the attachment with any installation.
Ceiling mounting
Attach safety cable
bracket
to ceiling joist with
screw and washer
Fig. 11
42" , 52" and 60" Lucian II | 9