Connection C - Electrical - Agilent Technologies TV 1001 SEM Manual De Instrucciones

17 Technical Information

Connection C - Electrical

Connection C - Electrical

Figure 47
The turbopump is connected to the controller through an 8-pin connector. Pins
B, C and D are the 3-phase supply to the motor, pin E is connected to the
pump ground, pins G and H are not connected, pins A and F reserved for
Agilent.
If the temperature sensor is disconnected, the pump will not start. To prevent
damage to the pump when the temperature exceeds 60 °C, the sensor
automatically cuts out the power supply.
286/296 TV 1001 SEM User Manual / 87-900-973-01 (H)