Appliance-Specific Safety Instructions; Original Accessories/Auxiliary Equipment - Parkside PPS 200 B2 Manual De Instrucciones

Appliance­specific safety instructions
To avoid the risk of injury or fire as well as
health risks:
■ When working outdoors, connect the appli-
ance via a fault current circuit breaker with
a maximum tripping current of 30 mA.
■ Use only an extension cable approved for
outdoor use.
■ Secure the workpiece! Use clamps/vice to
hold the workpiece firmly in place. This is
much safer than simply holding it in your hand .
■
In case of danger, remove the plug from the
socket immediately.
■ Always route the power cable towards the
rear, away from the appliance.
■ RISK OF FIRE DUE TO FLYING SPARKS!
Sanding metal generates sparks . Ensure that no-
body can be put at risk and that no combustible
materials are located in the immediate vicinity of
where you are working .
WARNING! TOXIC DUST!
► Dusts from materials such as leaded paint,
some types of wood and metal can be harm-
ful to your health .
Contact with or inhalation of these dusts can
represent a health hazard for the person
operating the appliance and other people in
the vicinity .
WARNING!
RISKS DUE TO DUST!
► When working for extended periods of time
on wood and, in particular, materials that
produce dust which is hazardous to health,
connect the appliance to an appropriate ex-
ternal dust extraction appliance . Wear safety
goggles and a protective dust mask!
■ Provide sufficient ventilation when working on
plastics, paints, lacquers, etc.
■ Do not soak the materials or the area to be
processed with liquids containing solvents.
■ Avoid sanding lead paint or other harmful
materials.
PPS 200 B2
■ Materials containing asbestos must not be
processed.Asbestos is a known carcinogen .
■ The device is designed for the dry surface
sanding of wood, plastic, metal and plaster
and painted surfaces.
■ Never work on moistened materials or damp
surfaces. Water entering a power tool will
increase the risk of electric shock .
■ Always hold the appliance firmly with two
hands while working.
■
Do not rest your hands next to or in front of
the appliance and the area being worked as
there is a risk of injury if you slip.
■ Always switch the appliance off and allow
the sanding sheet
putting the appliance down.
■ Always remove the plug from the power
socket during work breaks, when adjusting
the appliance (e.g. changing the sanding
sheet) and when it is no longer in use.
■ The appliance must always be kept clean, dry
and free from oil or grease.
Original accessories/auxiliary
equipment
■ Use only the additional equipment and acces-
sories specified in the operating instructions.
Using attachments or accessory tools other than
those recommended in the operating instruc-
tions can lead to a risk of injury .
to stop oscillating before
37
GB│MT │
■