Braun MultiQuick 9 MQ9087X Manual De Instrucciones página 16

• Fill the chopper with food and put on the lid
(10a).
• Align the chopper with the motor part (4) and
click together.
• To operate the chopper, switch on the appliance.
During processing, hold the motor part with one
hand and the chopper bowl with the other.
• Always chop harder foods (e.g. parmesan
cheese) at full speed.
• When chopping is complete, unplug and press
the release buttons (5) to detach the motor part.
• Lift the lid up. Carefully take out the blade before
pouring out the contents of the bowl. To remove
the blade, slightly turn it then pull it off.
Caution
• Do not use the chopper accessory to process
extremely hard foods, such as unshelled nuts,
ice cubes, coffee beans, grains, or hard spices
e.g. nutmeg. Processing these foods could
damage the blades.
• Never place the chopper bowl in the microwave
oven.
Recipe example: Honey-Prunes (as a
pancake stuffing or spread):
50 g prunes
100 g creamy honey
• Fill the «hc» chopper bowl with prunes and
creamy honey.
• Store at 3°C in refrigerator for 24 hours.
• Chop 1,5 seconds at maximum speed (fully press
the Smart Speed switch).
Food Processor Accessory
The food processor accessory (11) can be used for:
• Chopping, blending and mixing light batter;
• kneading dough (based on max. 250 g flour);
• slicing, shredding, julienning, and making french
fries.
Chopping (E)
Using the blade (11h) you can chop meat, hard
cheese, onions, herbs, garlic, vegetables, bread,
crackers, and nuts.
Refer to the Processing Guide E for maximum
quantities, recommended times and speeds.
Before Use
• Pre-cut foods into small pieces for easier
chopping.
• Remove any bones, cartilage, tendons and
gristle from meat to help prevent damage to the
blades.
• Remove stems from herbs, shell nuts.
• Make sure the anti-slip rubber ring (11g) is
attached to the bottom of the food processor
bowl.
16
Assembly and Operation
• Carefully remove the plastic cover from the
blade.
• The blade (11h) is very sharp! Always hold it by
the upper plastic part and handle it carefully.
• Place the blade on the center pin of the bowl
(11f). Press it down and give it a turn so that it
locks into place.
• Fill the bowl with food. Attach the lid (11a) to the
bowl with the latch (11e) positioned to the right of
the bowl handle and align with marks.
• To lock the lid, turn it clockwise so that the latch
engages with a click.
• Insert the motor part (4) into the coupling (11b)
until it locks.
• Plug in the appliance and insert the pusher (11c)
in the feed tube (11d).
• To operate the food processor, switch on the
appliance. During processing, hold the motor
part with one hand and the food processor bowl
on the handle.
• When chopping is complete, unplug and press
the release buttons (5) to detach the motor part.
• Press the lid latch (11e) and hold it. Turn the lid
(11a) counter-clockwise to unlatch it.
• Lift the lid up. Carefully take out the blade before
pouring out the contents of the bowl. To remove
and unlock the blade, slightly turn it then pull it
off.
Caution
• Do not use the food processor accessory to
chop extremely hard foods, such as unshelled
nuts, ice cubes, coffee beans, grains or hard
spices e.g. nutmeg. Processing these foods
could damage the blades.
• Never place the food processor bowl in the
microwave oven.
Using the blade (11h), you may also mix light batter
like a pancake batter or a cake mixture based on up
to 250 g of flour.
Recipe Example: Pancake Batter
375 ml milk
250 g plain flour
2 eggs
• Pour milk into the bowl, then add flour and finally
the eggs.
• Using full speed, mix the batter until smooth.
Kneading Dough (E)
Figure E also applies for the use of the kneading
hook (11i). The kneading hook is ideal for kneading
different dough types such as yeast or pastry.
Assembly and Operation
• Place the kneading hook on the center pin of the
bowl (11f). Press it down and give it a turn so that
it locks into place.
• Fill the bowl with flour (max. 250 g), then add the
other ingredients except the liquids.