Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

AFE LockN
FE (flash exposure) lock locks the correct flash exposure setting for any
part of the scene.
With the flash mode set to E-TTL II/E-TTL autoflash, press the camera's
<A> button to enable FE lock. On some cameras, press the <B> or
<7> button.
If the subject is too far away and underexposure may result, the <D>
icon will blink in the viewfinder. Move closer to the subject and perform
FE lock again. You can also increase the ISO speed and perform FE lock
again when using a digital camera.
If the target subject is too small in the viewfinder, the FE lock might not
be very effective.
18
1
Focus the subject.
2
Press the <A> button.
Aim the center of the viewfinder over
the subject and press the <A> button.
The Speedlite fires a preflash, and
the required flash output is retained in
memory.
"FEL" will be displayed in the
viewfinder for approx. 0.5 sec.
Each time you press the <A> button,
a preflash will be fired and a new
flash exposure reading will be locked.
3
Take the picture.
Compose the picture and press the
shutter button completely.
The flash fires when the picture is
taken.
8
(
)

Publicidad

Tabla de contenido
loading

Tabla de contenido