Canon SPEEDLITE 320EX Manual De Instrucciones página 41

Bulb (Long Exposure) Shooting
When you press the remote release button during bulb shooting, the
shutter opens two seconds later. Press the remote release button again
to close the shutter.
If the flash-ready lamp is not lit, pressing the remote release button does not
take a picture.
Be careful not to cover the remote control transmitter or wireless sensor
of the 320EX with your hand.
The remote control function has an operation range of about 5 m /
16.4 ft. from the front of the camera.
Check the shooting results while performing remote control shooting.
When the power switch on the 320EX is set to <ON> and you press the
remote release button, a picture is taken two seconds later in the same
way as with the Remote Controller RC-6. The 320EX does not fire.
2
Take the picture.
Check that the <D> lamp is lit, point
the remote control transmitter toward
the camera, and press the remote
release button.
The picture is taken two seconds
later.
When wireless flash shooting is
enabled and the power switch on the
320EX is set to <SLAVE>, the 320EX
fires.
39