Assembling The Trimmer - Stihl FSA 130 R Manual De Instrucciones

English
6

Assembling the Trimmer

6.1 Mounting the Loop Handle
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
1
2
6
7
► Fit the clamp (4) in the loop handle (3).
► Place the loop handle (3) with clamp (4) on the
drive tube (5).
► Fit washers (2) on the screws (1).
► Hold the clamp (6) against the drive tube (5).
► Insert screws (1) through holes in loop handle
(3) and clamps (4 and 6).
► Fit and tighten down the nuts (7) firmly.
6.2 Mounting Loop Handle with
Barrier Bar
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
1 2
► Insert nuts (2) in the barrier bar (1) so that the
holes line up.
► Fit the clamp (5) in the loop handle (3).
► Place the loop handle (3) with clamp (4) and
barrier bar (4) on the drive tube (6).
► Hold the clamp (7) against the drive tube (6).
► Insert and tighten down the screws (8).
32
3
4
5
3 4
5
6
7
8
6.3 Mounting and Removing the
Deflector
6.3.1 Mounting the Deflector
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
2
► Push the deflector (1) into the guides on the
gear housing as far as stop.
► Insert and tighten down the screws (2) firmly.
6.3.2 Removing the Deflector
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
2
► Take out the screws (2).
► Pull off the deflector (1).
6.4 Fitting and Removing the Skirt
6.4.1 Fitting the Skirt
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
1
2
► Slide the guide slot in the skirt (2) onto the
deflector (1) – it must snap into position.
► Push the line limiting blade (3) into the slot in
the skirt (2).
► Insert and tighten down the screw (4) firmly.
6 Assembling the Trimmer
1
1
3
4
0458-725-9821-D