Stihl FSA 130 R Manual De Instrucciones página 33

6 Assembling the Trimmer
6.4.2 Removing the Skirt
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
► Insert stop pin (2) into the hole in the skirt (1).
► Use the stop pin (2) to slide the skirt (1) off the
deflector.
The line limiting blade (1) can be left on the skirt.
6.5 Mounting and Removing the
Mowing Head
6.5.1 Mounting the Mowing Head
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
► Place the thrust plate (2) on the shaft (3) so
that its smaller diameter faces up.
► Fit the mowing head (1) on the shaft (3) and
turn it counterclockwise.
► Insert the stop pin (4) in the bore as far as
stop and hold it depressed.
► Rotate the mowing head (1) counterclockwise
until the stop pin (4) engages in position.
The shaft is now blocked.
► Tighten down the mowing head (1) firmly by
hand.
► Remove the stop pin (4).
6.5.2 Removing the Mowing Head
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
► Insert the stop pin in the bore as far as stop
and hold it depressed.
► Rotate the mowing head (3) until the stop pin
engages in position.
The shaft is now blocked.
► Unscrew the mowing head clockwise.
0458-725-9821-D
2
1
1
2
3
4
4
► Remove the thrust plate.
► Remove stop pin.
6.6 Removing and Installing Metal
Cutting Attachment
6.6.1 Mounting Metal Cutting Attachment
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
► Place the thrust plate (5) on the shaft (6) so
that its smaller diameter faces up.
1
► Place the metal cutting attachment (4) on the
thrust plate (5). If you are fitting a circular saw
blade or a grass cutting blade with more than
4 cutting edges: Its cutting edges must face in
the same direction as the arrow on the deflec‐
tor.
► Place the thrust washer (3) on the metal cut‐
ting attachment so that its raised side faces
up.
► Place the rider plate (2) on the thrust washer
(3) so that its closed side faces up.
► Insert the stop pin (7) in the bore as far as
stop and hold it depressed.
► Rotate the metal cutting attachment (4) clock‐
wise until the stop pin (7) engages in position.
The shaft is now blocked.
► Fit the nut (1) counterclockwise and tighten it
down firmly.
► Remove the stop pin (7).
6.6.2 Removing the Metal Cutting Attach‐
ment
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
► Insert the stop pin in the bore as far as stop
and hold it depressed.
English
1
2
3
4
5
6
7
33