Publicidad
Idiomas disponibles
Idiomas disponibles
FITTING THE BATTERIES.-
This
monitor
ALKALINE BATTERIES. To fit the
batteries, carefully insert the two "R-6"
type
batteries
compartment (A), Fig.1, making sure
that the battery's polarity is correct
(matching the battery's "+" terminal
with the "+" sign inside the battery
compartment, and the "-" terminal with
the "-" sign). Replace the battery
compartment cover.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the batteries
and wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
Important. Deposit all spent batteries
or
waste
packaging
containers, Fig.2.
FITTING THE ELECTRONIC
MONITOR.-
FITTING THE HAND-GRIP CABLE.
Take hold of the Hand-grip connector
(Z), sticking out of the main post (6),
and plug it into (N) located at the back
of the monitor (1), as shown in Fig.3.
ATTACHING THE FEEDBACK
CABLE.
Take hold of cable (M), which is
sticking up out of the main post, and
plug
it
into
connector (Y) at the back of the
electronic unit, as shown in Fig.3.
uses
two
1.5
into
the
battery
in
special
the
«sensor
English
FITTING THE ELECTRONIC
MONITOR.
volt
Remove screws (4), Fig.1, from the
base of the monitor, then slide the
front of the monitor onto the plate on
the main post (6), Fig.3, making sure
not to snag any of the wires, fit the
screws (4) removed previously and
tighten securely.
ELECTRONIC MONITOR.-
To give you greater control over the
exercise, this electronic unit gives
simultaneous read-outs of speed and
rpm alternating with distance, exercise
time, calories burnt and pulse rate.
The screen will switch itself on
automatically as soon as you start
exercising or by pressing any key on
the monitor. The monitor switches on
as soon as you start to exercise on the
machine.
Pressing the RESET key will reset the
value selected.
The monitor will switch itself off
automatically if the unit stands idle for
more than 4 minutes, with the screen
displaying the date and temperature.
SETTING THE DATE.-
Press the TOTAL RESET key to reset
the monitor, the year value will flash.
Press the key to adjust the value.
Press MODE to move on to the
month, use the key to adjust.
Press MODE to move on to the day,
use the key to adjust. Press
MODE to move on to the hour, use the
key to adjust. Press MODE to
iNput»
move on to minutes, use the key
to adjust.
7
Publicidad
