Kobalt SGY-AIR176NB Manual Del Usuario página 17

CARE AND MAINTENANCE
8. Using wrench (J), unscrew the Fluid Nozzle
(B) by turning counterclockwise and place it
in the secondary container to soak.
9. Pull out the Air Distribution Ring using Wire
Hook (not included) and place it in the
secondary container to soak.
10.After 3-5 minutes, remove each item and use a clean dry towel to wipe
off the entire item and inspect it for any remaining paint or dirt to wipe
remains.
IMPORTANT: To ensure all residue of material is removed from the part, use
a blow gun with an approved OSHA gun tip to blow any excess cleaning
solution off the part that a rag cannot get to.
If paint or dirt debris is still present, use a non-wire soft bristle brush and
brush the area.
NOTE: Soaking of parts may require longer to get all paint residue off the
part.
RE-ASSEMBLING SPRAY GUN
1. The Air Distribution Ring (L) can only be
inserted correctly one way
(See Figure 1 and 2).
NOTE: The line on the Air Distribution Ring (L)
(Figure 2) must be lined up to the hole shown
in Figure 1.
8
9
Wire Hook
1
2
17
J
B
L
L