External Battery Connection - Tripp-Lite SmartOnline SU5000RT4U Manual Del Propietário

Optional Connection

External Battery Connection

3
Your UPS comes with a robust internal battery system; external batteries are needed only
to extend runtime. Adding external batteries will increase recharge time as well as
runtime. The illustration shows the location of your UPS's External Battery Connector,
where you will insert the battery pack cable
your battery pack appear in the battery pack owner's manual. Make sure that cables are
fully inserted into their connectors. Small sparks may result during battery connection;
this is normal. Do not connect or disconnect battery packs when the UPS is running on
battery power.
NOTE: Select models feature a Battery Charge Level Switch
external batteries to these models, set the Battery Charge Level Switch (see diagram)
to the right (labeled "EXTERNAL BATTERIES"). This will increase your UPS's
charger output so the additional batteries charge faster.
CAUTION! DO NOT set the Battery Charge Level Switch to the right (labeled
"EXTERNAL BATTERIES") without an external battery connected. There is a risk
of damaging the UPS's internal battery system.
Internal SNMP/WEB Card Insertion
4
Remove the slot's cover to install an optional internal SNMP/Web accessory card (Model:
SNMPWEBCARD) to enable remote UPS monitoring and control via SNMP, Web or
telnet. Contact Tripp Lite Customer Support at (773) 869-1234 for more information,
including a list of available SNMP, network management and connectivity products.
201102170 932611.indd 8
(continued)
. Complete installation instructions for
3a
. If you connect any
3b
8
SU6000RT4U
Shown (Rear View)
3a
3b
4
3/30/2011 10:22:13 AM