Sensor Data Transmission; Clock; Set Clock; Alarm - Oregon Scientific BAR386 Manual De Usuario

SENSOR DATA TRANSMISSION

The sensor reception icon in the remote sensor area
shows the status.
ICON
and "- - . -"
(Outdoor
temperature area)
To search for a sensor:
Simultaneously, press and hold MEM and CHANNEL
for 2 seconds.
NOTE If the sensor is still not found, check the batteries,
obstructions, and remote unit location.

CLOCK

SET CLOCK

To set the clock:
. Press and hold MODE for 2 seconds.
2. Press or to change the settings.
3. Press MODE to confirm.
4. The settings order is: hour, minute, year, month, day
and language.
P/N: 300100700-00008-10 REV1
8/36
DESCRIPTION
Main unit is searching
for the sensor(s)
A channel has been found
and sensor signal is being
received
The sensor cannot be found.
Search for the sensor or check
batteries
NOTE The language options are (E) English, (D) German,
(F) French, (I) Italian, and (S) Spanish.
Press MODE to choose between the clock with seconds
and clock with weekday display modes.

ALARM

To set the alarm:
. Press and hold ALARM for 2 seconds.
2. Press / to set hour / minute.
3. Press ALARM to confirm.
To toggle alarms ON / OFF:
. Press ALARM to display alarm time.
2. Press ALARM again to turn alarm ON / OFF.
To silence the alarm:
• Press SNOOZE to silence it for 8 minutes.
OR
• Press any key except SNOOZE to turn the alarm off
and activate it again after 24 hours.
6
indicates alarm is ON.