Moving Jaws Adjustment - Bosch TCE 4460 Manual Del Usuario

2. Place the wheel on the floor, close to the antiabrasi-
ve supports of the beadbreaker; to put the blade (1)
close to the bead pressing the bead breaker control
pedal (2). The operation has to be carried out in dif-
ferent points of the wheel (rotating it manually) until
the bead doesn't come off completely.
i
Lubricate the side of the tire and the hump with
mounting paste to make the bead breaking opera-
tions easier.
2
3. Repeat the operation on the opposite side of the
wheel.
Warning – limb injury danger!
During operation of the bead breaking arm,
be careful in order to avoid that the limbs are
not crushed between the tire and the bead
breaker.
€
Do not insert limbs between the tire and
the bead breaking arm.
Warning – damage risk for RFT or UHP tires!
Cracks in case of operation on cold tire. Tire
explosion in case of high speed.
€
Inner temperature of the tire must be at
least 15 °C.
€
Read the Wdk publications available in Ger-
man and English! (www.wdk.de: mounting/
demounting instructions – tire overheating)
€
Before mounting put the tire in a temperate
room.
Robert Bosch GmbH
5.1.2
To work on wheels up to 30'', it is possible to adjust the
position of the 4 moving jaws as shown in pic.3:
1. Pull the cursor outwards.
2. Slide the mobile part of the aisle in the desired
position.
3. Release the cursor checking that it is correctly inser-
ted in the hole corresponding to the desired position
(the lane must not move).
1
Fig. 3:
Operating instructions | TCE 4460 | 35

Moving jaws adjustment

26"
28"
30"
Moving jaws adjustment
1 695 105 428
en
|
2010-02-16