Troubleshooting - Vornado Energy Smart 610DC2 Guia Del Propietario

TROUBLESHOOTING

PROBLEM
The unit fails to power on.
Airflow is weak or slow.
GFCI has tripped.
POSSIBLE CAUSE AND SOLUTION
Unit is not plugged in. Plug Power Cord into electrical outlet. Ensure the AC power cord is plugged into
the power supply and ensure DC power cord is plugged into the circulator.
Ensure unit fan speed setting is selected.
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
The outlet is worn or damaged. Try another outlet or contact a qualified electrician.
Unit set to a low speed setting. Adjust to a higher speed setting.
Airflow is blocked. Remove obstruction.
Adjust direction of airflow towards the user.
Under certain conditions, it is possible for a reset GFCI (Ground Fault Circuit Interrupter) outlet to trip
when the user is changing speeds on a Vornado circulator. In this event, change to an outlet that is not
connected to a GFCI device. It could also indicate a weak or defective GFCI outlet. Contact a qualified
electrician to check the GFCI outlet.
English
7