Publicidad
Idiomas disponibles
Idiomas disponibles
■
When using the device carelessly the inner parts resp. the housing could be damaged
and the operational performance reduced.
■
Press the lever for actuating the tool.
■
Release the lever to stop.
■
Note that the tool keeps running even after release of the lever.
■
Switch off the compressor and store it according to the operation manual after having
finished work.
■
Only use dry, clean air with approx. 90 PSI or 6.3 bar max. pressure. Dust, flammable
vapours and too high humidity can destroy the motor of a pneumatic device.
■
Do not remove labels, replace damaged labels.
■
Keep hands, loose clothing and long hair away from moving parts of the unit.
■
Check the air pressure and adjust if necessary until the correct operational pressure is
reached.
14. Maintenance and care
■
Lubrication:
Pneumatic tools have to be lubricated throughout their lifetime. Motor and ball bearings
need compressed air to power the tool. As the moisture in the compressed air causes motor
corrosion, the motor must be lubricated daily. We therefore recommend using an integrated
lubricator.
■
FÖRCH-Unit Lubricator to be assembled to pneumatic tools.
■
Lubricating the pneumatic motor manually:
Disconnect the device from the compressed air supply and keep up with the air inlet up-
wards. Apply one or two drops of special compressed air oil into the air inlet. Reconnect the
tool to the compressed air supply, cover the air outlet at the unit with a towel and operate
it for a few seconds. Never use flammable or volatile liquids such as kerosene, diesel or
gasoline for lubricating this tool.
ATTENTION!
Excess oil in the motor will be discharged immediately through the air outlet.
WARNING!
Never point air outlet towards persons or objects. The air outlet is located on the backside
of the handle.
■
Maintenance
Always disconnect the device from the compressed air supply before carrying out mainte-
nance work. In case of daily use, a quarterly maintenance is required, at the latest however
after 1000 operating hours. Damaged or worn components such as O-rings, bearings, rotary
blades etc. have to be replaced and all moving parts must be lubricated.
Only use the spare parts recommended by the manufacturer otherwise warranty expires.
When disposing of the components, lubricants etc., please make sure that the appropriate
guidelines for environmental protection are followed.
For cleaning the tool or its individual parts we recommend the use of benzine. Never clean
with detergents or acid cleaners, esters (organic compound from acids and alcohol), acetone
(ketone), chlorinated hydrocarbons or nitrocarbon-containing oils. Do not use chemicals with
low flashpoint.
To obtain service please get in touch with your dealer or with the FÖRCH Service Center.
Publicidad
