Start-Up - WEG CFW100 Manual Del Usuario

5.2 START-UP

This section describes the power-up of the inverter with HMI operation, using the minimum
connections of Figure 3.1 on page 18
Furthermore, two types of control will be considered: V/f control (scalar) and vector control V V W.
For further details on the utilization of these types of control refer to the CFW100 programming
manual.
DANGER!
High voltages can be present, even after the disconnection of the power supply.
Wait at least 10 minutes for full discharge.
DANGER!
Il peut rester une tension élevée même après le débranchement de l'alimentation
électrique.
Attendre au moins 10 minutes pour que la machine se décharge.
Figure 5.1: HMI display when powering up
and without connections in the control terminals.
First Time Power-Up and Start-Up
CFW100 | 29