WEG CFW100 Manual Del Usuario página 4

Summary of Revisions
The information below describes the revisions made to this manual.
Revision
00
Modification in
01
ATTENTION!
Check the frequency of the power supply.
In case the power supply frequency is different from the factory setting (check
P403), it is necessary to set:
P204 = 5 for 60 Hz.
„
P204 = 6 for 50 Hz.
„
It is only necessary to set these parameters once.
Refer to the programming manual of the CFW100 for further details about the
programming of parameter P204.
2 | CFW100
Description
First edition.
Table B1 on page 121 and addition of installation
recommendations.
Chapter
-
-