Electrical Installation; Identification Of The Power Terminals And Grounding Points - WEG CFW100 Manual Del Usuario

Installation and Connection

3.2 ELECTRICAL INSTALLATION

DANGER!
The following information is merely a guide for proper installation. Comply with
„
applicable local regulations for electrical installations.
Make sure the AC power supply is disconnected before starting the installation.
„
The CFW100 must not be used as an emergency stop device. Provide other
„
devices for that purpose.
DANGER!
Les informations suivantes constituent uniquement un guide pour une
„
installation correcte. Respectez les réglementations locales en vigueur pour
les installations électriques.
Vérifiez que l'alimentation secteur CA est débranchée avant de commencer
„
l'installation.
Le CFW100 ne devra pas être utilisé comme un dispositif d'arrêt d'urgence.
„
Utilisez des dispositifs additionnels appropriés dans ce but.

3.2.1 Identification of the Power Terminals and Grounding Points

The location of the power, grounding and control connections can be seen in
page 125.
Description of the power terminals:
L/L1 and N/L2: AC power supply must be connected to L/L1 and N/L2.
„
U, V and W: connection for the motor.
„
PE: grounding connection.
„
The maximum tightening torque of the power terminals and grounding points must be checked
in Figure B3 on page 125.
16 | CFW100
Figure B3 on