Tabla de contenido
Publicidad
WIRE LEAD AND CABLE INSTALLATION
EXPLODED DIAGRAM
INSTALLATION CHART
Step
Procedure/Part name
WIRE LEAD AND CABLE
INSTALLATION
1
Buzzer
2
Steering boss cover
3
Handlebar assembly
4
QSTS cable
5
Handlebar switch lead
6
Throttle cable (with corrugated
tube)
7
Band
Q'ty
Follow "Step" order for installation.
NOTE:
Install the front seat so that no parts are
dropped into the engine compartment.
NOTE:
1
Route the QSTS cables and buzzer lead
G
1
through the port side in the steering con-
1
sole.
2
Route the handlebar switch lead and throt-
G
1
tle cable through the starboard side in the
steering console.
1
G
Position the corrugated tube for the throt-
tle cable as shown in the illustration so
2
that the tube attaches to the end of the
outer throttle cable.
– 6 –
Service points
E
Publicidad
Tabla de contenido
