Exploded Diagram - Yamaha WaveRunner XLT800 Manual De Montaje

EXPLODED DIAGRAM

Step Procedure/Part name
1 Shift cable
2 Shift cable joint
3 Shift cable holder
Bolt 6 × 14 mm (0.24 × 0.55 in)
4
Q'ty
1
WARNING
1
The cable joint should be screwed in more
G
than 8 mm (0.31 in).
G Be sure to fit the projection on the cable
holder into the groove on the outer cable.
NOTE:
1
To install the shift cable, install the shift
2
cable holder with one bolt, adjusting the
cable so that the groove of the outer cable is
aligned with the projection of the cable
holder, and then install the remaining bolt
to the cable holder.
– 5 –
Service points
E