Detaching The Control Panel; Attaching The Control Panel; Switch-Off Time (Off Timer) - Blaupunkt John Deere MP36 Instrucciones De Manejo

Control panel

Detaching the control panel


Press the button 2.
The control panel opens out towards you.

Hold the control panel by its right side
and then pull the control panel straight
out of the bracket.
Notes:
• The device is switched off after a
time preset by you. For instructions,
please read the section "Switch-off
time (OFF TIMER)" in this chapter.
• All the current settings are saved.
• Any CD already inserted in the device
remains there.

Attaching the control panel


Hold the control panel approximately at
a right angle to the device.

Slide the control panel into the de-
vice's guides that are positioned on the
left and right at the lower edge of the
housing. Push the control panel care-
fully into the bracket until it clicks into
place.

Carefully flip up the control panel until
it clicks into place.
0
If the device was still switched on when you
detached the control panel, it will automati-
cally switch on with the last setting activat-
ed (radio, CD, CD changer or AUX) when
the panel is replaced.

Switch-off time (OFF TIMER)

After opening the control panel, the device
is switched off after an adjustable time. You
can set this time from 0 to 30 seconds.

Press the MENU button 9.

Press the or button : repeatedly
until the displays shows "OFF TIMER".

Adjust the time with the buttons
:.
When you have finished making your chang-
es,

press the MENU button twice 9.
Note:
If you set the switch-off time to 0 sec-
onds, the device is switched off imme-
diately after opening the control panel.
2.
1.