ClicBot KY002CK10 Manual Del Usuario página 24

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 77
连接
热点连接适合没有 Wi-Fi 网络或者 Wi-Fi 网络信号差的场景。
* 热点连接的操作方法:
1. 在主脑模块 Brain 的屏幕上从底部向上滑动进入系统菜单,再选择设备图
,点击"热点连接",生成热点二维码;
2. 打开 ClicBot App ,选择
。点击"连接 Brain" 后选择 "热点连接",
进入扫描连接状态;
3. 用移动设备的摄像头扫描主脑模块的热点二维码,即可建立热点连接。
主脑模块生成热点二维码
扫描热点二维码建立热点连接
44
安全信息
Any changes or modifications not
expressly approved by the party
responsible for compliance could void
the user's authority to operate the
equipment.
GB19865-2005、GB6675.1-2014、
GB6675.2-2014、GB6675.3-2014、
GB6675.4-2014
NOTE:This equipment has been
tested and found to comply with the
limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This device complies with part 15 of
This equipment generates, uses and
can radiate radio frequency energy
the FCC Rules. Operation is subject
to the condition that this device does
and, if not installed and used in
accordance with the instructions, may
not cause harmful interference (1)
this device may not cause harmful
cause harmful interference to radio
interference, and (2) this device must
communications. However, there is
accept any interference received,
no guarantee that interference will not
including interference that may cause
occur in a particular installation
undesired operation.
If this equipment does cause harmful
interference to radio or television
reception,which can be determined by
turning the equipment off and on, the
RSS-Gen Issue 4 December 2014"&"CNR-Gen
user is encouraged to try to correct
4e Décembre 2014:
the interference by one or more of the
--English:
following measures:
This device complies with Industry Canada
--Reorient or relocate the receiving
licence-exempt RSS standard(s).
Operation is subject to the following two
antenna.
conditions: (1) This device may not cause
--Increase the separation between the
interference, and (2) This device must accept
equipment and receiver.
any interference, including interference that may
--Connect the equipment into an outlet
cause undesired operation of the device.
on a circuit different from that to which
--French:
Le présentappareilestconforme aux
the receiver is connected.
CNR d'Industrie Canada applicables
--Consult the dealer or an experienced
aux appareils radio exempts de licence.
radio/TV technician for help.
L'exploitationestautorisée aux deux conditions
suivantes:
The device has been evaluated to meet
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareildoit accepter tout
general RF exposure requirement. The
brouillageradioélectriquesubi, mêmesi le
device can be used in portable
brouillageest susceptible d'encompromettre le
exposure condition without restriction.
fonctionnement.
FCC ID: 2AWR5-KY002
IC ID: 26344-KY002
安全隐私
45

Publicidad

Tabla de contenido
loading

Tabla de contenido