Light Emitting Diodes (Led) On Charger; Switching On - Stihl MSA 160 T Manual De Instrucciones

English
3)
Electromagnetic interference or
fault. Take the battery out of the
power tool and refit it. Switch on the
machine – if the LEDs continue to
flash, the battery has a malfunction
and must be replaced.
4)
Electromagnetic interference or
fault. Take the battery out of the
machine. Use a blunt tool to
remove dirt from the contacts in the
battery compartment. Refit the
battery. Switch on the power tool –
if the LEDs still flash, the power tool
has a malfunction and must be
checked by a servicing dealer –
STIHL recommends an authorized
STIHL servicing dealer.
62
Light Emitting Diodes (LED)
on Charger
1
The LED (1) on the charger may glow
continuously green or flash red.
Green continuous light ...
... indicates the following:
The battery
is being charged
–
is too hot and must cool down
–
before charging
See also "LEDs on battery".
The green LED on the charger goes off
as soon as the battery is fully charged.
Red flashing light ...
... may indicate the following:
No electrical contact between
–
battery and charger – remove and
refit the battery
Malfunction in battery – see also
–
"LEDs on Battery".
Malfunction in charger – have
–
checked by a servicing dealer.
STIHL recommends an authorized
STIHL servicing dealer.

Switching On

When delivered, the battery is not fully
charged.
It is advisable to charge the battery
completely before using it for the first
time.
Remove the chain scabbard
N
Secure the chain saw so that it
N
cannot be accidentally switched on
again – press the hand guard
forward towards the tip of the bar
(position ƒ)
Inserting the battery
Insert battery in the battery
N
compartment of the machine –
press gently until it clicks into place
– top of battery must be flush with
the top edge of the housing
MSA 160 T