Worx WG784E Traducción De Las Instrucciones Originales página 14

1. FITTING ThE hANDLE
(See Fig. B1~B5)
1) Remove the screws (X 2) on the both side
of deck. (See Fig. B1)
2) Insert the lower handle (9) into the holes on
the deck provided. (See Fig. B2)
3) Secure with the screws provided.
(See Fig. B2)
4) Attach the upper handle (7) with the bolts
and lock cam lever (8) to the lower handle
(9). (See Fig. B3)
5) Tightening the two Lock cam levers. Check
that the handle is FULLY secured.
The cam lever pressure can be adjusted by
adjusting the lock cam lever (8) clockwise/
counter-clockwise. DO NOT OVER TIGHTEN.
(See Fig. B4)
NOTE: Ensure the bolts are fully inserted
through the handles before fitting the handle
knobs.
6) Attach the cable clips (2) provided, to the
upper and lower handle. Insert the cable
into the clips ensuring there is enough
cable slack. (See Fig. B5)
14
2. GRASS COLLECTION BAG ASSEmBLy
Connect the grass box handle to the box top
as shown in Fig. C1-C4.
Step 1: press the front of the handle briefly.
(See Fig. C2)
Step 2: Then push it forward. (See Fig. C2)
Step 3: push down the back of the handle.
(See Fig. C2)
Step 4: Finally, clip the plastic clips over the
metal frame. (See Fig. C3)
wARNING: Don't fit the handle in
reversed direction. Fit the handle as
shown in Fig. C1.
3. GRASS COLLECTION BAG FITTING
(See Fig. D1, D2, D3)
1) Turn the mower off, wait until blade stops
and remove safety key (6).
2) Raise the safety flap (10) and hold it up,
ensure that the mulching insert has been
removed.
3) pick up the grass collection bag by the
handle, and position grass collection bag
on the lower hooks (a) on the mower deck
(See Fig. D2).
Cordless lawn mower
All manuals and user guides at all-guides.com
4) Release the safety guard to lock the
NOTE: Depress the grass collection bag
slightly to ensure that it is completely
installed.
4. REmOVING/EmPTyING
Hold the grass collection bag, lift the safety
flap (10) and hold up. Remove grass collection
bag (4).
tightly before using. Never lift the safety flap
(10) when the lawn mower is being used
without fitted grass collection bag.
5. hANDLE ADJUSTmENT (See Fig. E)
The upper handle can be adjusted to 3
different height positions. Release the lock
cam lever, set the upper handle to one of the
three height positions, and make sure to insert
the pin into the hole. Then reset the lock cam
lever.
NOTE: Always check that the upper handle is
fixed firmly.
6. FITTING/REmOVING BATTERy
(See Fig. F1, F2)
REmOVING BATTERy
pull out the battery with the battery handle
directly. (See Fig. F1)
NOTE: Be careful not to drop the battery onto
your foot or on the ground when removing it.
FITTING BATTERy
put the battery into the battery container;
make sure the battery is fitted correctly.
(See Fig. F2)
OPERATION
1. STARTING AND STOPPING
(See Fig. G1, G2)
machine is switched off. Allow the motor/blade
to stop rotating before switching "on" again.
Do not rapidly switch off and on.
grass bag into position. Ensure the grass
collection bag is installed securely
(See Fig. D3).
wARNING! Always check the safety
flap can close the discharge outlet
wARNING! The blade continues
to rotate for a few seconds after the
EN