Battery Care - Worx WG787 Manual De Instrucciones

charging is complete (approximately 10-12
hours to charge a fully discharged battery)
6. After the battery is fully charged the green
light will turn on and charge it on for 15
seconds to indicate a full charge. After 15
seconds the green light and charges will
turn off to save power.
Note: if the battery is defective, the
red light on the charger will flash.
The red and green lights will only
function when the charger is
connected to both the battery and
wall receptacle.
7. The charger is a smart charger and can
stay connected to the battery and wall
receptacle for extended periods of time
without fear of damaging the battery or
charger. The charger will automatically
turn on and off periodically to ensure the
battery is fully charged.

BATTERY CARE

The battery in your cordless lawnmower is a
24-volt sealed lead acid system. The battery
14 14
can be stored in any position without fear of
leakage.
• For optimal battery life and performance
the battery should be fully charged every 2
months during storage.
• For optimal battery life and performance
the battery should be fully charged after
each use.
• Store the battery in a cool dry location.
• The battery can be safely stored down to
14°F (-10°C).
• The battery does not need to be fully
discharged before recharging.
• Initially 2 to 3 charging cycles may
be required after purchase to achieve
maximum run time capacity.
The battery is maintenance free. ADDITIONAL
BATTERIES can be obtained from the
Customer Helpline 1-866-354-9679.
ASSEMBLY
iMPorTaNT! Before you assemble
the lawn mower, check the accessories
3-in-1 Cordless Lawn Mower
All manuals and user guides at all-guides.com
according to the information, make sure the
accessories are complete.
1. FiTTiNG ThE haNDLE (See Fig.B1- B5)
1) Remove the screws (b) on the both side of
2) Insert the lower handle (8) into the holes on
3) Secure the lower handle bars to the deck
4) Attach the upper handle (6) with the bolts
5) Tightening the two Lock cam levers. Check
6) Attach the cable clips (2) provided, to the
2. GraSS CoLLECTioN BaG aSSEMBLy
1) Attach the grass bag handle to the grass
a. Identify the front and rear of both the
b. Insert the front (I) portion of the handle into
c. Secure the front portion of the handle in
d. Insert and secure the rear portion of the
2) Clip the plastic clips of the grass bag over
will not remain secure. Make sure to fit
deck. (Fig B1)
the deck provided. Be sure to carefully align
the screw holes found on the lower handles
with the screws holes found on the deck
(b). (See Fig B1, B2)
with the screws (b) provided. (See Fig B2)
and lock cam lever (7) to the lower handle
(8). (Fig B3)
that the handle is FULLY secured.
The cam lever pressure can be adjusted
by rotating the lock cam lever (7) or (8)
clockwise/counter-clockwise. DO NOT OVER
TIGHTEN.(Fig. B4)
NoTE: Ensure the bolts are fully inserted
through the handles before adjusting or
tightening the cam levers.
upper and lower handle. Insert the cable
into the clips ensuring there is enough
cable slack. (Fig B5)
bag assembly as shown in F ig C1-C4.
handle and the grass bag assembly.
(Fig C1)
position. (Fig C2)
place by pushing the front portion of the
handle forward (II). (Fig C2)
handle in position by pushing down on the
back (III) of the handle ensuring it "clicks"
into position. (Fig C2)
the metal frame. (Fig C3)
warNiNG: Make sure to not fit the
handle in the reverse direction as it
EN