Receiving Instructions; Safety Issues; Important; Product Description - Enerpac ATM-9 Hoja De Instrucciones

1.0 RECEIVING INSTRUCTIONS

Visually inspect all components for shipping damage.
Shipping damage is not covered by warranty. If
shipping damage is found notify carrier at once. The
carrier is responsible for all repair and replacement
costs resulting from damage in shipment.
safety first
Read all instructions, warnings and cautions carefully.
Follow all safety precautions to avoid personal injury
or property damage during system operation. Enerpac
cannot be responsible for damage or injury resulting
from unsafe product use, lack of maintenance or
incorrect product and/or system operation. Contact
Enerpac when in doubt as to the safety precautions
and applications. To protect your warranty, use only
ENERPAC hydraulic oil.
A CAUTION is used to indicate correct operating or
maintenance procedures and practices to prevent
damage to, or destruction of equipment or other
property
A WARNING indicates a potential danger that requires
correct procedures or practices to avoid personal
injury.

2.0 SAFETY ISSUES

Failure to comply with the
following cautions and warnings
could cause equipment damage
and personal injury.
IMPORTANT: Minimum age of the operator
must be 18 years. The operator must have
read and understood all instructions, safety
issues, cautions and warnings before starting to operate
the Enerpac equipment. The operator is responsible for
this activity towards other persons.
WARNING: To avoid personal injury and
possible equipment damage, make sure all
hydraulic
maximum pressure of 10,000 psi [700 bar].

IMPORTANT:

overloading. Use hydraulic gauges in each
hydraulic system to indicate safe operating
loads. It is your window to what is happening in the
system.
WARNING: Do not overload equipment.
Overloading causes equipment failure and
possible personal injury.
components withstand
Minimize the
CAUTION: Make sure that all system
components are protected from external
sources of damage, such as excessive heat,
flame, moving machine parts, sharp edges and
corrosive chemicals.
CAUTION: Avoid sharp bends and kinks
that will cause severe back-up pressure in
hoses. Bends and kinks lead to premature
hose failure.
WARNING: Immediately replace worn or
damaged parts with genuine Enerpac parts.
Enerpac parts are designed to fit properly
and withstand rated loads.
WARNING: Always wear safety glasses. The
operator must take precaution against injury
due to failure of the tool or workpiece
DANGER: Do not handle pressurized hoses.
Escaping oil under pressure can penetrate
the skin, causing serious injury. If oil is
injected under the skin, see a doctor immediately.
WARNING: Never pressurize uncoupled
couplers. Only use hydraulic equipment in a
coupled system.
We recommend the use of special loosening
liquids or sprays. Enerpac hydraulic torque
wrenches offer both square and hexagon
drive units to loosen or tighten bolts and nuts. Enerpac
offers nut splitters in case a nut can not be removed.

3.0 PRODUCT DESCRIPTION

The ATM-9 Alignment Tool is intended for use in typical
maintenance and installation procedures. It allows the
realignment of misaligned flanges within a 9 Ton [90 kN]
the
physical capacity. For example, it may be used to assist
in the replacement of ring and other type joints.
risk of
The ATM-9 is a hydraulically operated tool actuated
by a hydraulic cylinder and hand pump. The maximum
operating pressure is 10,000 psi [700 bar].
The use of these instructions will promote the safe use
and maximum service life of the tool. All sections of this
instruction sheet should be read prior to using the tool.
2 2
IMPORTANT: DO NOT lift hydraulic
equipment by the hoses or couplers. Use
the carrying handle or other means of safe
transport.