Nuts And Bolts; Auger Shaft; Assistance And Repairs; Warranty Coverage - Stiga ST 526 S Manual De Instrucciones

7.7

NUTS AND BOLTS

• Keep all nuts, bolts and screws tight to be sure
the equipment is in safe working condition.
• Regularly check that the fixing nuts of the
discharge chute are correctly tightened.

7.8 AUGER SHAFT

To facilitate the rotation of the auger, it is
recommended to regularly grease the holes
on the auger shaft using a syringe greaser.
To grease:
– Remove the cotter pins and
the safety pins (fig. 18.A).
– Grease the holes and rotate the auger
on the shaft a few times to allow the
grease to flow inside the shaft.
– Refit the safety
pins and the cotter pins (fig. 18.A).
8. STORAGE
When you intend to put your machine
away for more than 30 days:
1. Drain the fuel supply circuit:
– Close the fuel tap (fig. 15.B).
– Start the engine of the machine
and leave it running until it stops
when the fuel runs out.
2. Replace the engine oil if this
operation has not been performed
during the last three months.
3. Thoroughly clean the snowplough.
4. Check the snowplough for any
damage. If necessary, repair it.
5. If the paint is damaged, restore
it to prevent rust formation.
6. Protect the metallic surfaces
exposed to rust formation.
7. Store the snowplough in a
closed room, if possible.

9. ASSISTANCE AND REPAIRS

This manual provides all the necessary
information to run the machine and for correct
basic maintenance operations which can
be performed by the user. Any regulations
and maintenance operations not described
herein must be carried out by your Dealer
or Authorised Service Centre, which have
the necessary knowledge and equipment to
ensure that the work is carried out correctly,
maintaining the correct degree of safety and the
original operating conditions of the machine.
Any operations performed in unauthorised
centres or by unqualified persons will totally
invalidate the Warranty and all obligations
and responsibilities of the Manufacturer.
• Only Authorised Service Centres can carry
out guaranteed repairs and maintenance.
• The Authorised Service Centres only
use genuine spare parts. Genuine
spare parts and attachments have been
designed specifically for machines.
• Non-genuine spare parts and accessories
are not approved. Use of non-genuine
spare parts and accessories cause
the warranty to be voided.
• It is advisable to send your machine
once a year to an Authorised Service
Centre for servicing, assistance
and safety device inspection.

10. WARRANTY COVERAGE

The warranty covers all material and
manufacturing defects. The user must
follow all the instructions provided in
the accompanying documentation.
The warranty does not cover damage caused by:
• Failure to become familiar with the
documentation accompanying the machine.
• Carelessness.
• Incorrect or prohibited use or assembly.
• Use of non-genuine spare parts.
• Use of attachments not supplied or
not approved by the manufacturer.
The warranty does not cover:
• Normal wear and tear of consumables,
such as drive belts, augers, headlights,
wheels, safety bolts and wires.
• Normal wear and tear.
• Engines. Engines are covered by
the warranty provided by the relative
manufacturer in compliance with the
specified terms and conditions.
The purchaser is protected by his or her own
national legislation. The purchaser's rights under
the national laws or his or her own country are
not in any way restricted by this warranty.
EN - 13
Автотовары «130»