Using Your Induction Hob - Cooke & Lewis CLIND30 Manual Del Usuario

01

Using your induction hob

1. Touch the ON/OFF control (C). The hob will beep once and the zones will show "–" to indicate
standby mode.
Note: If you do not select a cooking zone and power level within one minute, the hob will switch
off automatically.
2. Place a pan suitable for induction cooking on a cooking zone; ensure that the base of the pan and
the cooking surface is clean and dry.
3. Choose the zone using (A) "
seconds, "–" will be displayed.
4. Select the output using the power control (D) from 0-9 and cooking commences. You can modify
this at any time during cooking.
POWER DOWN
Reference
• If you don't choose a heat setting within 1 minute, the induction hob will automatically switch off.
You will need to start again at step 1.
• You can modify the heat setting at any time during cooking.
When you have finished cooking
1. Select the cooking zone (A).
2. Alter the power output level (D) to zero.
Note: The hob will display "H" to show the cooking zone is too hot too touch.
This is due to the convection of heat generated in the pan transferring back to the cooking surface of
the hob during use and is perfectly normal.
Important
The display will flash with
• you have not placed a pan on the correct cooking zone
• the chosen pan is not suitable for induction cooking
• the pan is too small or not correctly centred on the zone
As a result the hob will automatically switch off after one minute.
GLOA10301_200000017 v8d R.indd 35
" or " " and "0" will flash. If no power level is selected within 5
POWER UP
Normal Power
1200 W
2000 W
and the selected power output if:
Boost Power
1500 W
2300 W
35
10/05/2017 16:13