General Safety Notes; Notes On Ul Approval; Product Description; Intended Use - SICK WLF4F Manual De Instrucciones

1

GENERAL SAFETY NOTES

1 General safety notes
2

Notes on UL approval

en
3

Product description

3.1

Intended use

3.2

Operating elements and status indicators

16 O P E R A T I N G I N S T R U C T I O N S | WLF4F
Read the operating instructions before commissioning.
■
■
Connection, mounting, and configuration may only be performed by trained
specialists.
■
NO
2006/42/EC
Not a safety component in accordance with the EU Machinery Directive.
SAFETY
■
Do not install the sensor at locations that are exposed to direct UV radiation
(sunlight) or other weather influences, unless this is expressly permitted in the
operating instructions.
When commissioning, protect the device from moisture and contamination.
■
These operating instructions contain information required during the life cycle of
■
the sensor.
The device shall be supplied from an isolating transformer having a secondary overcur‐
rent protective device that complies with UL 248 to be installed in the field rated either:
a) max 5 amps for voltages 0 ~ 20 V (0 ~ 28.3 V peak), or
b) 100 / Vp for voltages of 20 ~ 30 V (28.3 ~ 42.4 V peak).
Alternatively, they can be supplied from a Class 2 power supply.
UL Environmental Rating: Enclosure type 1
The WLF4F is an opto-electronic photoelectric retro-reflective sensor (referred to as
"sensor" in the following) for the optical, non-contact detection of objects, animals, and
persons. A reflector is required for it to function. If the product is used for any other
purpose or modified in any way, any warranty claim against SICK AG shall become void.
Table 7: Operating elements and status indicators
WLF4Fx-xxxxxxA0Zxx
No possibility of setting
4 3
8027380.1DTW /2021-12-13 | SICK
Subject to change without notice