Operation; Opening/Closing The Trigger Gun; Operating Modes - Kärcher HDS 5/11 U/UX Manual Del Usuario

Ocultar thumbs Ver también para HDS 5/11 U/UX:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 63
DANGER
Risk of injury on account of electric shock!
– Unsuitable electrical extension cables
can be hazardous. Only use electrical
extension cables outdoors which have
been approved and labelled for this pur-
pose and have an adequate cable
cross-section.
– Always unwind extension lines com-
pletely.
– The plug and coupling of the extension
cable used must be watertight.
ATTENTION
The highest allowed net impedance at the
electrical connection point (refer to techni-
cal data) is not to be exceeded. In case of
confusion regarding the power impedance
present on your connection, please contact
your utilities provider.

Operation

DANGER
Danger of explosion! Do not spray flamma-
ble liquids.
DANGER
Risk of injury! Never use the appliance
without the spray lance attached. Check
and ensure proper fitting of the spray lance
prior to each use. The screw connection of
the spray lance must be finger-tight.
DANGER
Risk of injury! Hold the hand spray gun and
the spray pipe firmly with both hands.
DANGER
Risk of injury! The trigger and safety lever
may not be locked during the operation.
DANGER
Risk of injury! Contact Customer Service if
the safety lever is damaged.
ATTENTION
– Risk of damage! Never operate device
with an empty fuel tank. The fuel pump
will otherwise be destroyed. This also
applies to cold water operation.
– Risk of damage! Never operate the ap-
pliance without a filter in the water con-
nection.
– Risk of damage! Do not place any objects
(hose, etc.) on or over the chimney.
All manuals and user guides at all-guides.com
– Device with hose drum:
Illustration
 Unlock the hood lock using a screwdriv-
Illustration
 Hook in the appliance hood (see arrows),
 To open the trigger gun: Actuate the
 To close the hand spray gun: Release
Risk of injury! Switch the appliance off prior
to replacing nozzle and activate hand spray
gun until device is pressureless.
 Secure the trigger gun. To do so, push
 Replacing the nozzle.
Illustration
0/OFF = Off
1 Operating with cold water
2 Operating with hot water
 Set appliance switch to desired operat-
The device starts briefly and turns off, as
soon as the working pressure is reached.
 Release the trigger gun. To do so, push
When activating the hand spray gun the de-
vice switches back on.
Note: If no water comes out of the high
pressure nozzle, vent pump.
Vent pump:
 With open hand spray gun turn device
– 5
EN
Risk of damage. Always unwind high-
pressure hose completely.
Open/close the hood
er, pivot the appliance hood forward
and unhook it.
pivot it up and lock in the hood lock.

Opening/closing the trigger gun

safety lever and trigger.
the safety lever and trigger.
Replace the nozzle
DANGER
the safety catch towards the front.

Operating modes

Turning on the Appliance
ing mode.
the safety catch towards the back.
on and off multiple times with the device
switch.
21

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Hds 5/13 u/uxHds 5/15 u/ux

Tabla de contenido