Interrupting Operation; Operation With Detergent - Kärcher HDS 5/11 U/UX Manual Del Usuario

Note: By dismantling the spray lance from
the hand spray gun, the venting process is
accelerated.

Interrupting operation

 Release the pulling lever; the device will
switch off.
Secure the trigger gun. To do so, push
the safety catch towards the front.
 Release the trigger gun. To do so, push
the safety catch towards the back.
Release the pulling lever again; the de-
vice will switch on again.
Select spray type
 Close the hand spray gun.
 Secure the trigger gun. To do so, push
the safety catch towards the front.
 Turn the casing of the nozzle till the de-
sired symbol matches the marking.
High pressure circular spray
(0°) for specially stubborn dirt
Flat low pressure spray
(CHEM) for operating using de-
tergents or cleaning at low
pressure.
High pressure flat spray (25°)
for large dirt areas

Operation with detergent

– For considerate treatment of the envi-
ronment use detergent economically.
– The detergent must be suitable for the
surface to be cleaned.
Illustration
 Take out detergent suck hose.
 Turn filter on the detergent suction hose
in order to dispense the detergent.
 Suspend end of suction hose in a con-
tainer filled with detergent.
 Set nozzle to "CHEM".
22
All manuals and user guides at all-guides.com
 Set the detergent concentration accord-
Note: To prevent damage due to too much
pressure, always position high pressure ray
first from a greater distance towards object
to be cleaned.
Recommended cleaning method
– Loosen the dirt:
 Spray detergent economically and let it
– Remove the dirt:
 Spray off loosened dirt with the high
Removal of light contaminations and clear
rinse, i.e.: Gardening tools, terrace, tools, etc.
 Set the appliance switch to "1".
Scalding danger!
 Set the appliance switch to "2".
 Completely close the filter at the deter-
 Set the appliance switch to "1".
 Open the hand spray gun and rinse the
Danger of scalding from hot water! After op-
eration with hot water, the device must be
operated with openend handgun with cold
water for at least two minutes.
 Shut off water supply.
 Open the hand spray gun.
 Switch on the pump with the power
 Close the hand spray gun.
 Set the appliance switch to "0/OFF".
– 6
EN
Cleaning
ing to the surface to be cleaned.
work for 1...5 minutes but do not let it
dry up.
pressure jet.
Operating with cold water
Operating with hot water
DANGER
After operation with detergent
gent suction hose (-).
appliance for at least 1 minute.
Turn off the appliance
DANGER
switch and allow to run for about 5-10
seconds.